EZTR – Should I clamp the Flex pipe to the wall or ceiling?
No. The support is done through the Base Junction Support piece. Routing near walls or the ceiling will often lead...
- Home
- Flex Vent
-
-
EZTR – Where on the flex vent should I be making a cut?
The flex vent should always be cut in the valley of the piping. If your measured distance indicates that it... -
EZTR – The Flex vent is too long in length. Can I leave it that way?
No. The Flex vent may sag creating a downward section of exhaust flow. During operation, condensate may collect in this... -
EZTR – What should I use to cut the Flex vent?
The recommended tool is either a PVC cutter or utility knife. Avoid using a saw or any tool which can... -
EZTR – The flex vent was cut too short. What can I do?
The Flex vent cannot be extended in length. You will have to either: Relocate the unit higher on the wall....